Thread: DXF with tool offset
Hybrid View
-
25-03-2014 #1
Last Activity: 02-10-2024
I have to admit to being an ex C/L combat flyer, specifically the flying wing type, we used to reckon an old shit house door would fly on control line with a big enough engine fitted. My pride and joy engine used to be a McCoy35
The good thing about flying wings is that all the ribs are the same with a big square(ish) leading edge and a wide triangular trailing edge.Last edited by EddyCurrent; 25-03-2014 at 10:48 PM.
Spelling mistakes are not intentional, I only seem to see them some time after I've posted
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Tool Pre-setter
By Leadhead in forum Tool & Tooling TechnologyReplies: 6Last Post: 28-09-2013, 10:56 AM -
Looking for a tool ( oohharrr )
By Fivetide in forum Tool & Tooling TechnologyReplies: 3Last Post: 24-07-2013, 10:28 PM -
round over tool for Alu.
By jcb121 in forum Tool & Tooling TechnologyReplies: 3Last Post: 19-07-2013, 12:14 AM -
tool for aluminum on uk
By edgas10 in forum Tool & Tooling TechnologyReplies: 1Last Post: 26-04-2011, 11:23 AM -
What tool would you use for this?
By Kai in forum Tool & Tooling TechnologyReplies: 1Last Post: 21-03-2011, 06:08 PM
Bookmarks