Thread: Fixed Gantry Router
Hybrid View
-
30-04-2009 #1
I definitely ordered a coupling with 6.35 on one end and 6 on the other. The only thing is when it arrived there were two in the box. I just assumed I'd gotten lucky or something, but now I am think one was 6 on both ends, and the other 6.35 on both ends. So I might have accidently put on the 6.35 on both ends. I'll investigate tomorrow.
As you can see, its a speed daemon :)
Edit: Also, your right, the z is a little high. There are two things though. First of all, I have a milling vice which will add quite a bit of height. Secondly the table still needs beefed up a bit, and lastly, if need be, the whole gantry can come down a little.Last edited by lateAtNight; 30-04-2009 at 09:47 PM.
-
09-05-2009 #2
Right... half moons. It all makes sense now! The T bed on top won't have those right?
That is indeed the housing I'm using. And yup, 16mm ballscrews.
A little concern though. There is only about 6.5 cm between the bottom of the table and the actual table that the machine lies on. Is there going to be enough space with those braces?
Regarding the PSU... I think I'll hang onto it. For £40 I think I'd rather keep it on the off chance that I might need it at some point. Would be £65 new.
Just looking at the beefier drivers though and they are £118! Ahahahahahah, OMG, could be a while until I can afford to convert a mill then.
Good work as always. Look forward to seeing the T plate.
Cheers!
Dave.
-
09-05-2009 #3
There is just over 7cm I think... maybe 1mm to spare?
Edit: I take it you calculated that?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: Monster fixed gantry router for aluminium & wood
By jonboycnc in forum DIY Router Build LogsReplies: 9Last Post: 12-01-2014, 11:26 PM -
BUILD LOG: Vertical fixed gantry. Design & build. (Steel/epoxy)
By Greeny in forum DIY Router Build LogsReplies: 8Last Post: 19-08-2013, 08:26 PM -
RFQ: RQF: Router Gantry plates
By lateAtNight in forum Projects, Jobs & RequestsReplies: 1Last Post: 27-12-2012, 04:56 AM -
BUILD LOG: New build - fixed gantry mill using extruded profile
By toolchimp in forum DIY Router Build LogsReplies: 3Last Post: 09-11-2012, 04:10 PM -
Bellows for a gantry mill/router
By Smiler in forum Milling Machines, Builds & ConversionsReplies: 0Last Post: 19-11-2008, 09:25 PM
Bookmarks