Website idea.

[magicniner]

I personally think the rfq section should have stayed open

That would have been a sensible option, one request for 3-Axis milling work had internal corner radii of .5mm in a fairly deep pocket, but only after my effort to steer the requester as his drawing initially required square internal corners in a 3-Axis job ;-)

[magicniner]

I've just looked at the RFQ section again and I think there's scope for a Request For Help With Requests For Quote section where no quotes are allowed but the requester might be helped to hone their request to the point where it makes sense/is possible/contains enough of a specification for a quote.
I've tried helping by PM but to no avail and have now given up :-(