. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 06-04-2014 #1
    Jonathan's Avatar
    Lives in Leicester (Home) or Nottingham University (2nd Home), United Kingdom.
    Jonathan
    Last Activity: 05-04-2020 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 3,571. Received thanks 325 times, giving thanks to others 8 times. Referred 1 members to the community.
    When the machine follows a curved line, both axes are accelerating. If the acceleration setting in the motor tuning is too low, the machine will therefore have to slow down. So check what your X and Y accelerations are set to.

    Edit: The above is probably irrelevant, didn't spot that you said it was fine with circles.
    Last edited by Jonathan; 06-04-2014 at 12:07 PM.
    Old router build log here. New router build log here. Lathe build log here.
    Electric motorbike project here.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need to slow down a signal due to Safe Torque Off alarm
    By corkcnc in forum General Electronics
    Replies: 0
    Last Post: 04-06-2014, 11:35 PM
  2. how to smooth stl model, smooth curves out of straight lines
    By chris in forum DeskProto
    Replies: 4
    Last Post: 21-01-2014, 11:00 PM
  3. Help! Steppers losing steps and making a racket under slow feed..
    By fasteddy in forum Stepper & Servo Motors
    Replies: 23
    Last Post: 06-08-2011, 03:03 PM
  4. Forum Slow
    By pcstru in forum General Discussion
    Replies: 3
    Last Post: 27-01-2011, 03:54 PM
  5. stepper speed very slow
    By jonm in forum Stepper & Servo Motors
    Replies: 17
    Last Post: 02-11-2009, 12:39 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules