Threaded View
-
13-04-2014 #11
Last Activity: 27-04-2015
Ger --- thzats my final option, am tryin g to avoid winding it off.
Jazz ---- Yes, i think if i can get them loose, that will give me the room i need. I just dont have the exact tool i need, typical,
Question. if am unable to loosen the motor, will it be problematic winding it off and just putting the balls back in . Ie is it worth me putting more effort into removing them bolts, or is it ok to wind the baring of the screw ?-- not just the pully but the baring set listed above ?
--------update-------
unwound the screw of the baring,--- needs a good clean out anyhow....Last edited by george uk; 13-04-2014 at 03:22 PM. Reason: updated
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Advice needed on Amadeal
By croy in forum General DiscussionReplies: 13Last Post: 21-08-2015, 01:28 PM -
bit of advice needed for first mill
By jmac80 in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 06-04-2014, 10:59 PM -
Quick Advice Needed - F&S
By Tenson in forum Tool & Tooling TechnologyReplies: 1Last Post: 01-01-2013, 06:38 PM -
First steps, advice needed
By Wobblycogs in forum Gantry/Router Machines & BuildingReplies: 6Last Post: 02-11-2012, 02:30 PM -
Advice needed for Z Design
By Hobgoblin in forum Linear & Rotary MotionReplies: 8Last Post: 10-09-2012, 09:18 PM
Bookmarks