right, took a few days to get everything in position so i can get to work on it. I need to transfer the picture i have sofar of the electronics to post them, am picking up the extra box tomorrow. so will post picture of that. I have a number of options with power and would like to explore everyones thoughts on the options am looking at, i need to work out

1. what's possible
2. what problems each may have
3. costs

in relation to power.

as as stated above, machine is 3 phase, 3* 0.85kw yaskawa sgdb 10vd and 15vd servos plus drivers. that i definitely want to use, a 5kw or 3.4kw spindle and driver ( frenic 5000g9s ), that if possible would like to use. It also, has 2 motors to run a saw and multi ( 15 bit ) drill head mech. and an air ram attached to each to lower out of the hood. that if i can use i will, to some extent. It has a compressor ( will put KW up tomorrow ).

I have fully independant standard supply to the workshop ( 240v ac )

I am re-designing the machine to be multi use, so i can explore a number of options for electrical supply. and this is need a bit more info on the advice above, i will try post the pictures from my phone, and i still need to take a picky of one part ( additional box )., so

generator options, is it doable from a 3 phase genny, what power ( KW ) ?

conversion to single phase. would it mean totally replacing everything,

rotary converter, does this make more sense than a genny.

any opinions