Do you allow price check threads?

[dynamis_dk]

I would argue than my effort to find its value via a forum of experiences cnc fans would count as market research :)

[dynamis_dk]

Heres a quick rundown of the parts, any item numbers etc I can see and a quick photo. More then happy to take any other angles needed if it helps.

http://www.violentangel.net/stuff/sale/cncstuff.jpg

Two setups, make up of the below parts:

THK BF15 End block (with bearings)
THK BK15 End block (With Bearings)
Ballnut - Zero Backlash Double internal Ball (85mm long / 63mm flange, 6 mounting holes and threaded hole for grease nipple)
Following is wrote on the body.
PIM9739
11231
785701-01

ballscrew - 10mm pitch, 25mm. End to end = 410mm, total ballscrew movement 220mm. 12mm shaft to mount to stepper/servo etc.

Any ideas gratefully received...

[Web Goblin]

Done the same type of helpful bit as Jazz in the past and got stiffed as well and learned from it. If your selling something put a price on it that you think is correct and you will be happy with. If buying then pay what your happy with. If its too expensive then wait for another one to come along in your price range. Unless of course you just want to get in before Jazz buys it.

[GTJim]

My mistake

[dynamis_dk]

Few posts above - http://www.mycncuk.com/forums/market...html#post57364