. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 22-06-2014 #11
    gorbo's Avatar
    Lives in Kidderminster UK, United Kingdom.
    gorbo
    Last Activity: 03-01-2016 Has been a member for 9-10 years. Has a total post count of 65.
    I had this same problem, I built a PC (xp) with a PCIe Card parallel port , it was a 3 axis machine but only 2 would run, in this case it was X, swapped wires around and no joy, in desperation I tried a PC with a built on parallel port and it worked fine, so I purchased a Intel board with a built on parallel port and problem was solved, hope this helps
    Last edited by gorbo; 22-06-2014 at 06:42 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Stepper motor tunning wiring
    By handyoodman03 in forum Stepper & Servo Motors
    Replies: 47
    Last Post: 11-01-2013, 05:49 PM
  2. Stepper Motor Wire Colour Codes
    By c cunningham in forum Stepper & Servo Motors
    Replies: 14
    Last Post: 26-01-2011, 02:13 PM
  3. CY or SY cable for stepper motor wiring?
    By Jonathan in forum General Electronics
    Replies: 6
    Last Post: 26-09-2010, 06:25 PM
  4. Stepper motor wiring
    By Buba b in forum Stepper & Servo Motors
    Replies: 5
    Last Post: 28-03-2010, 06:16 PM
  5. Stepper Motor Wiring (Screened?)
    By pequod in forum Stepper & Servo Motors
    Replies: 19
    Last Post: 03-08-2009, 10:15 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules