Thread: Stepper wiring/colour coding
Threaded View
-
16-04-2014 #1
Hi guys, I'm new here so apologies in advance for any textbook errors!
I'm looking for some help with some steppers I've just received. The wires coming out of the motor are colour coded as usual, so you can look up on the data sheet which coil they're hooked up to... However on mine, (all three are the same) none of them have the colours in the same order, so if I were to follow the data sheet by colour, then surely they would be wired differently and probably incorrectly!?!
Take a look at what I mean:
Motor number 1:
Number 2:
And number 3:
The motors are Zapp Automation SY60STH86-3008BF (SY60STH88-3008BF) (this link is for a single axle variant, but the datasheet for mine are on the same page. - You may notice I asked my question on their site already, but I don't think it was understood, I probably didn't explain it well enough!
Here's the data sheet:http://www.zappautomation.co.uk/en/a...attachment=140
Lastly, I'm assuming I'm going to have to re-order these wires so that I can follow the data sheet, and there looks like where the wires go into the motor body, the plastic connector bit might be removable... There are what I think are small plastic release clips, but I can't get it to budge and would rather not break it... Any ideas?
Thanks very much in advance to anyone who can help me out here!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stepper motor tunning wiring
By handyoodman03 in forum Stepper & Servo MotorsReplies: 47Last Post: 11-01-2013, 05:49 PM -
Stepper Motor Wire Colour Codes
By c cunningham in forum Stepper & Servo MotorsReplies: 14Last Post: 26-01-2011, 02:13 PM -
CY or SY cable for stepper motor wiring?
By Jonathan in forum General ElectronicsReplies: 6Last Post: 26-09-2010, 06:25 PM -
Stepper motor wiring
By Buba b in forum Stepper & Servo MotorsReplies: 5Last Post: 28-03-2010, 06:16 PM -
Stepper Motor Wiring (Screened?)
By pequod in forum Stepper & Servo MotorsReplies: 19Last Post: 03-08-2009, 10:15 AM
Bookmarks