Aluminium cutting

[Boyan Silyavski]

I find that Fz=D/100 usually too much. Especially about aluminum. Not talking about roughing bits. Tools 0-2mm is one thing, 3mm is another thing, 4-6 mm another, and so on.

I have Gwizard trial installed but some how this program doesn't engage me, may be the price and subscription put me off.
Just found the free online FSWizard and actually the data it gives is quite near the manufacturer data and very very near at my actual cutting data. So i am quite convinced and maybe even will buy the payed version

The bits i use are mainly Kyocera, razor sharp and polished. Now looking at their data below, some conclusions about how things develop with sizing and type of operation can be drawn. This is quite more realistic than others i have seen.





Vc - cutting speed
f - chip load or feed per tooth
Fr- feed rate mm/min
D- diameter of carbide bit
U- nimber of teeth on cutter
p=3.14


Ae - side removal
Ap - face removal


1.
determine spindle speed rpm/min depending an operation/roughing, slotting, finishing/


RPM=(Vc*1000)/(p*D)


2.


Calculate feed rate mm/min:


Fr=f*U*RPM