Mach 4 Demo Released Today (Looksy only NO Motion)

[Ger21]

I'm not worried about price so much if it works. It'll probably be at least 18-24 months before I get my new router running, and at this time I'm leaning towards the CS Labs products. They seem to have the best reputation as far as support and updates t o their plugin. DSPMC (Vital Systems) seems good too, but their prices are a little out of my range.

[JAZZCNC]

I'm not worried about price so much if it works. It'll probably be at least 18-24 months before I get my new router running, and at this time I'm leaning towards the CS Labs products. They seem to have the best reputation as far as support and updates t o their plugin.

Awsome product Gerry I use the IP-M on all the 3 axis routers I build and have one on my machine. The quality is first rate and the software just works without any hassle. I've had absolutly no dropouts, faults, noise issues of any kind and I've even run my HF Tig welder along side it and it didn't bat an eyelid.

Just wished the IP-M could run slaved motors and the IP-S was touch cheaper. At then minute it's just too expensive for most stepper based 4 axis machines so end up with the ESS or the Russian PLCM E3 for 4 axis slaved motors. I can tell you thou the IP-M knocks the spots off both of these in performance with steppers and reliabilty. The spinlde speed control is rock solid. 24v IO is a dream and the Din rail terminals make connection really nice and easy, again just quality stuff. The whole unit is quality and built to industrial spec and it shows, thing just works and works good straight out the box.