Hi Folks,

Have moved up to a DIYCNC BOB and driver boards (PCPSS-3PS & 25PS drivers). Have wired it all up and wife is getting the 25 pin female to female so that can hook up the parallel cable this afternoon. Only looking at which way would be best for setting up the E-stop.

Looking at putting it beofre the power supply as the kills it all dead and stops it cold, but than it also does just that. The question is what is the best way using the above boards and a 2NC Estop (I can put another NC in the switch housing as there is room) to wire things up for both safety and control of the system (so it will stop and if possible be able to be repowered without complete loss of any of the systems down stream. It also looks like I am going to need a power switch as the PS does not ome with one but that is not a problem nor is it critical at this point (power cords with circut breakers do have secondary functions).

Thanks for any and all help.

Michael