-
15-05-2014 #21
-
15-05-2014 #22
I suggested to you early in this thread. Talk to Permagrit, he can bond whatever grade you require onto any length/diameter of wood/metal that you want. the end could be turned down to fit in a drill chuck and you will have a very simple device that will doo exactly what you want. G.
-
15-05-2014 #23
I remember you saying that but I never knew that they make custom tools? Another thing to remember is that I can only go slow in my pillar drill with something this long because the other end is not fixed so any wobbled in the rod makes the thing spin wildly and could possibly kill me lol. Will speak to them tomorrow and see what they say. Cheers
-
15-05-2014 #24
-
16-05-2014 #25
-
16-05-2014 #26
maybe because its ali bar. alot softer then steel.
-
16-05-2014 #27
That's true but I am still not sure if the knurls would actually do the job? There is something else I have in mind though may buying a brake cylinder hone with an extension rod and trying that to see if that works. Any clue how good will a 180 grit stone perform on wood?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Small workbench drum sanders ?
By Fivetide in forum Marketplace DiscussionReplies: 7Last Post: 26-11-2013, 12:53 PM -
Make your own Super- PID ... not that hard to make ! .... says electronics genius!
By Buba b in forum General ElectronicsReplies: 4Last Post: 26-04-2013, 08:37 AM -
How would you make these, or something near enough...
By irving2008 in forum General DiscussionReplies: 8Last Post: 22-09-2012, 09:36 PM -
Can somebody make me one of these?
By Imtryin in forum General DiscussionReplies: 0Last Post: 28-06-2011, 06:53 PM -
The 'ultimate rev counter' thread...
By irving2008 in forum Electronic Project BuildingReplies: 36Last Post: 15-08-2010, 10:18 AM
Bookmarks