Threaded View
-
02-05-2014 #11
Last Activity: 30-08-2024
i think my kit i have has 2 course, 2 medium and 2 fine kurl wheels.
the best one to get it the clamp type, that clamps on top and bottom of the workpiece.
the single wheels ones have to push against the workpiece and can stress the lathe bearings
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Small workbench drum sanders ?
By Fivetide in forum Marketplace DiscussionReplies: 7Last Post: 26-11-2013, 12:53 PM -
Make your own Super- PID ... not that hard to make ! .... says electronics genius!
By Buba b in forum General ElectronicsReplies: 4Last Post: 26-04-2013, 08:37 AM -
How would you make these, or something near enough...
By irving2008 in forum General DiscussionReplies: 8Last Post: 22-09-2012, 09:36 PM -
Can somebody make me one of these?
By Imtryin in forum General DiscussionReplies: 0Last Post: 28-06-2011, 06:53 PM -
The 'ultimate rev counter' thread...
By irving2008 in forum Electronic Project BuildingReplies: 36Last Post: 15-08-2010, 10:18 AM
Bookmarks