Hybrid View
-
02-05-2014 #1
Hey FatFreddie, this is very interesting tool. I think rather than putting a threaded bar through the middle I might just put these shapers of my round aluminium bar. I might just give this a go and see what happens. Thanks a bunch man!!!
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Small workbench drum sanders ?
By Fivetide in forum Marketplace DiscussionReplies: 7Last Post: 26-11-2013, 12:53 PM -
Make your own Super- PID ... not that hard to make ! .... says electronics genius!
By Buba b in forum General ElectronicsReplies: 4Last Post: 26-04-2013, 08:37 AM -
How would you make these, or something near enough...
By irving2008 in forum General DiscussionReplies: 8Last Post: 22-09-2012, 09:36 PM -
Can somebody make me one of these?
By Imtryin in forum General DiscussionReplies: 0Last Post: 28-06-2011, 06:53 PM -
The 'ultimate rev counter' thread...
By irving2008 in forum Electronic Project BuildingReplies: 36Last Post: 15-08-2010, 10:18 AM
Bookmarks