Hybrid View
-
02-05-2014 #1
Last edited by Jonathan; 02-05-2014 at 09:41 PM.
-
02-05-2014 #2
Thanks Jonathan and Tornado, I think I have my answer. Will get a steel bar and knurl it. Do the knurling tools come with various pitches so that I can knurl it in such a way that the protrusions are long a sharpish? Thanks
-
02-05-2014 #3
i think my kit i have has 2 course, 2 medium and 2 fine kurl wheels.
the best one to get it the clamp type, that clamps on top and bottom of the workpiece.
the single wheels ones have to push against the workpiece and can stress the lathe bearings
-
02-05-2014 #4
Can you recommend a course wheels one please? Also can the top and bottom wheels reduce the wobble in my round bar too? Not sure why a think piece of ali is wobbling when it turns?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Small workbench drum sanders ?
By Fivetide in forum Marketplace DiscussionReplies: 7Last Post: 26-11-2013, 12:53 PM -
Make your own Super- PID ... not that hard to make ! .... says electronics genius!
By Buba b in forum General ElectronicsReplies: 4Last Post: 26-04-2013, 08:37 AM -
How would you make these, or something near enough...
By irving2008 in forum General DiscussionReplies: 8Last Post: 22-09-2012, 09:36 PM -
Can somebody make me one of these?
By Imtryin in forum General DiscussionReplies: 0Last Post: 28-06-2011, 06:53 PM -
The 'ultimate rev counter' thread...
By irving2008 in forum Electronic Project BuildingReplies: 36Last Post: 15-08-2010, 10:18 AM
Bookmarks