Thread: ES-D1008 + CSMIO/IP-S wiring
Threaded View
-
03-05-2014 #1
Hi folks.
Would anybody have knowledge to share about wiring ES-D1008 (Leadshine easy servo drive) and CSMIO/IP-S (ethernet motion controller). My concern of the control signals is that. Following manuals of both take's me nowhere. In CSMIO/IP-S manual there is diagram utilising PUL+,PUL-,DIR+,DIR- and FAULT+,FAULT-. In witch case ENA+,ENA-,INP+,INP- are missed out. Do I just leave them unconnected or use some looping strategy as if connecting with BOB as shown on the ES-D1008 manual. If that the case what goes with what be cause my little BOB is widely different than what's on CSMIO/IP-S witch only have step and direction while BOB have VCC,DIR,STP and ENA.
What do I do???
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CSMIO/IP-M vs Ethernet SmoothStepper (Begone foul parallel port!)
By Greeny in forum Control Hardware & SystemsReplies: 20Last Post: 14-11-2013, 11:59 PM -
cnc wiring
By crossleymarko in forum Gantry/Router Machines & BuildingReplies: 1Last Post: 09-04-2012, 09:35 PM -
wiring help
By deannos in forum Motor Drivers & ControllersReplies: 3Last Post: 08-06-2011, 02:20 PM -
help me for wiring
By ali hedi in forum General ElectronicsReplies: 0Last Post: 28-11-2010, 01:20 PM -
Wiring Help
By Toddy in forum Motor Drivers & ControllersReplies: 8Last Post: 23-11-2010, 01:48 PM
Bookmarks