Thread: advise on drive shaft diameters
-
14-05-2014 #1
hi all looking at a conversion to a sieg x2plus and its looking like 12mm ball screws. my concern is that a usual drive spigot for this is 6mm and I was wondering to its strength, any imput? thanks in advance
-
14-05-2014 #2
What size motors are you proposing to use ? these ones have a 6.35mm shaft for example,Nema23 Stepper Motor 2.2Nm
This might be useful reading, http://www.ausrocketry.com/forum/vie...hp?f=32&t=4002Last edited by EddyCurrent; 14-05-2014 at 10:34 PM.
Spelling mistakes are not intentional, I only seem to see them some time after I've posted
-
15-05-2014 #3
Many thanks,eddy,probably the ones you have put,will read up tonite at home,head is filling up with data sheet info,I even think some of it is making sense aswell,ball nut support blocks to draw up next. All good fun. Cheers...
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
dc motor - spindle / shaft drive
By dsc in forum Spindles & Drive MotorsReplies: 21Last Post: 01-06-2013, 10:42 AM -
I need advise again
By habibuzziwa in forum General DiscussionReplies: 14Last Post: 08-10-2012, 10:08 AM -
I need advise
By habibuzziwa in forum General DiscussionReplies: 7Last Post: 03-10-2012, 10:50 AM -
Simple Solution- Drive 1" Ball Screw Shaft with NEMA-23-Size Stepper Motor Shaft
By LoveLearn in forum Gantry/Router Machines & BuildingReplies: 5Last Post: 08-02-2012, 01:52 AM -
Ho do you measure end mill diameters?
By HankMcSpank in forum General DiscussionReplies: 10Last Post: 21-11-2011, 12:04 AM
Bookmarks