tree problems!

[JAZZCNC]

Type g64 into Mdi and press enter before running code just to be sure your in CV mode. This looks very much like it's running in exact stop mode (g61).

Check code for g61 using replace & find.

Failing that then it's because there's too many lines making up the arc's so turn down tuning or reduce number of lines.!

[JAZZCNC]

Ah didn't see Simon's post so looks like he's found the reason if not running g61. ..! (How's my baby running Si.?)

[firetrappe]

Ah didn't see Simon's post so looks like he's found the reason if not running g61. ..! (How's my baby running Si.?)

It's running great thanks mate. It munched its way through a block of ali quite happily yesterday without breaking a sweat (or a cutter!)

[JAZZCNC]

It's running great thanks mate. It munched its way through a block of ali quite happily yesterday without breaking a sweat (or a cutter!)

Clearly states in my terms and conditions "For wood use only" so your first job is great big macking lump of Ali.!!. . . . That's it Warranty void. .