. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-06-2014 #9
    manofgresley's Avatar
    Lives in Swadlincote, United Kingdom.
    manofgresley
    Last Activity: 24-11-2014 Has been a member for 9-10 years. Has a total post count of 117.
    Hi Jazz

    I had i minor wiring fault, i had not stripped the insulation back far enough on one cable therefore there was no contact. Since i corrected this, all 3 of my motors now move, my Z & X axis are ok the drive that did not work yesterday now chatters when i select it on the toggle, i have checked the dip switches, they are set to 4.2 amp, any more ideas?

    My Ena + & Ena - were connected, i have disconnected them.
    Last edited by manofgresley; 05-06-2014 at 12:22 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. switching from steppers to servos - STEP / DIR control
    By dsc in forum Stepper & Servo Motors
    Replies: 6
    Last Post: 18-06-2014, 12:41 PM
  2. Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
    By craynerd in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 16-03-2014, 07:29 PM
  3. FOR SALE: 24v 20 amp ABB switching power supply £90
    By gavztheouch in forum Items For Sale
    Replies: 0
    Last Post: 07-02-2014, 07:42 PM
  4. Home switching
    By Vard in forum General Electronics
    Replies: 6
    Last Post: 14-03-2012, 08:32 PM
  5. Driver box
    By John S in forum General Electronics
    Replies: 1
    Last Post: 21-06-2009, 12:46 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules