Threaded View
-
10-04-2017 #21
Geia sou, Vageli.
I found this thread after googling for 1605 runout. I happen to have 3 lengths of 750~800mm 1605s that show up to 1.3mm (!) of runout.
I put them on v-blocks and tried to apply force in the middle. I can bend them both by hand or by using a clamp (with a v groove on its plastic end). However, no matter how long I hold this position once I release them they spring back to their original shape.
I am leaving the clamp on one overnight to see if this helps. I am pushing down 0.8m (i.e. 0.15mm further down from the middle 0.65mm position).
I was wondering what did you eventually do with yours.
Cheer,
Elias
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Centec 2 ballscrews
By jonnydeen in forum Lead Screws, Nuts & SupportsReplies: 29Last Post: 11-07-2023, 09:53 AM -
machining ballscrews
By T0rnado69 in forum Lead Screws, Nuts & SupportsReplies: 11Last Post: 13-04-2014, 11:39 PM -
machined ballscrews
By wilfy in forum Lead Screws, Nuts & SupportsReplies: 15Last Post: 30-07-2012, 05:42 PM -
Two ballscrews on both X and Y axis?
By Jonathan in forum Gantry/Router Machines & BuildingReplies: 2Last Post: 02-02-2012, 01:55 AM -
supports for ballscrews
By leadinglights in forum Lead Screws, Nuts & SupportsReplies: 2Last Post: 27-04-2010, 12:31 PM
Bookmarks