Making a part on hobby CNC miller

[Dean jeffery]

Holding should be no problem, bored 3 jaw chuck machine the shaft end, turn over machine the rest. But may flex and want to shove it over or pull it out.
Think I'm asking to much TBH just hoped somebody has done something simlar with success.

I made just 1 of these on the lathe for personal use, only 1 off in the world made from Ti, also made a few of these from Ti again nobody has Ti versions.



1 off the above has been made from alloy, but sold the lathe and now people are wanting Ti versions.

The carriers above look like this when done.




The clutch bell







Sent from a GS4 using tapacrap

[Wal]

Lovely work man.

Wal.

[Dean jeffery]

Lovely work man.

Wal.

Cheers
But now abit stuck on what route to take, if access was not an issue i would simply buy a cnc lathe and miller. But limited to just 790mm down the side of my house, so needs a small lathe and miller.

Just thought i would buy a lathe, machine what i wanted (needed) then sell on, not nothing people would want them when complete.