Making a part on hobby CNC miller

[Dean jeffery]

Cheers for that yes it does help, means I've no chance of doing it lol.
But around half hr is not a lot of time, clearly this is the most technical part 3d wise I would need to make it's only for RC use.
They do sell alloy diff cases that would need 3d but would be easy than above.
Would also need editing but dint want to ask, the arms would look better if they was smoothed out into the dia.

Size of the stock could be given, the outa dia was 68mm but has left rads on the out side of the bolt holes. But at the time this was not a problem looking at the alloy version, but if I was to make these again then the dia would need to be 69.5 then I could get a full cycle around the bolt hole and would look evan better.

Thanks for the info

Sent from a GS4 using tapacrap