-
05-06-2014 #1
Hi there, does anyone know how to realign the head/spindle on an Easiturn 3? I have one and it runs out quite badly.
The Denford site is as usual little to no help.
There's a couple of us wanting to know, so any information would be greatly appreciated.
thanks
Nemo
-
11-12-2014 #2
hi i had the same problem if you take the small cover that gives access to the spindle off there is a caphead bolt in each corner of the headstock base if you undo them there is a small amount of movement in the headstock that will allow you to move the spindle side to side.
cheers glen
-
13-05-2020 #3
Hi,
could you please tell me what lubrication is required for the Easiturn 3 i am now rebuilding. I read that Mobil Vactra3 is ok for the centralised lube but what is used for the workhead spindle. It looks like the chuck end of the spindle has a grease nipple but when i removed the spindle bearings there was no evidence of any grease.
Regards
Colin
-
13-05-2020 #4
When i removed my headstock one of the bolts was sheared, so worth checking.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Denford ORAC lathe spindle nose upgrade
By rnr107 in forum Metalwork Project ShowcaseReplies: 19Last Post: 29-04-2019, 07:45 AM -
denford easiturn
By scotty in forum General ElectronicsReplies: 8Last Post: 27-06-2016, 09:24 PM -
RFQ: Spindle for a Denford ORAC
By rnr107 in forum Projects, Jobs & RequestsReplies: 0Last Post: 07-11-2012, 05:20 PM -
Eazicnc on denford easiturn
By pistolknight in forum Denford LathesReplies: 2Last Post: 24-11-2011, 07:55 PM -
Denford Triac Spindle Fault
By Sam_Smith in forum Denford MillsReplies: 5Last Post: 04-05-2011, 11:07 PM
Bookmarks