Thread: 150mm dia x 15mm wall Ali pipe
-
10-06-2014 #1
Hi, Anyone know where i can source a short length of about 50-100mm of the above at a reasonable price please?
I have found a 150mm solid bar and then machine out the excess but it'd be nice to need to machine it.
TIALast edited by r0bsk1; 10-06-2014 at 10:04 AM.
-
10-06-2014 #2
I have 140mm x 10mm wall
-
11-06-2014 #3
Oooh that's so close ill remeasure just in case. How much is it and can you cut to size?
-
11-06-2014 #4
How much do you need, I can cut but will be with a bandsaw/jigsaw so will not be accurate, you will have to clean up.
Maybe be possible to part off in my lathe with a bit of jiggery pokey, how accurate do you needLast edited by johnsattuk; 11-06-2014 at 09:46 AM.
-
12-06-2014 #5
Lets say 75mm of tube. This will give me 5mm for cutting and adjustment.
Last edited by r0bsk1; 12-06-2014 at 02:05 PM.
-
12-06-2014 #6
I hope you meant 75mm lol :)
-
12-06-2014 #7
Yup i did. edited....
Think the bike would fall over with 75m stuck to the side of it
-
12-06-2014 #8
Hi
Have dragged it out of my loft where it has been for ~50yrs
May not be what you want now that I have got it where I can measure it. I guess it is actually 5.5" od with .375 wall ( 149.5 x 9.6 )
I don't know the spec but it rings quite well and machines OK, it was an off-cut from the switch arms at a large sub-station.
~80mm would be £10 in the post.
-
12-06-2014 #9
Cool its worth a shot for a tenner Paypal ok for you?
How much of it do you have? I might have the rest if it fits
-
12-06-2014 #10
PayPal OK, same as my addr. PM your address to send to.
Got about 240mm left, also have ~450mm x 118 OD x 110 ID. from same source.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
3mtr CNC pipe profiling machine.
By D-man in forum Gantry/Router Machines & BuildingReplies: 13Last Post: 23-08-2013, 08:49 PM -
wall cnc like the wall saw
By crossleymarko in forum Machine DiscussionReplies: 10Last Post: 25-03-2012, 11:24 AM -
wall and floor fixing am I the only one ????????????
By luke11cnc in forum General DiscussionReplies: 15Last Post: 30-12-2011, 11:45 PM -
Pipe thread in 22 tpi???
By Robin Hewitt in forum Machine DiscussionReplies: 3Last Post: 21-09-2010, 11:19 AM -
CNC Wall art from JPG
By BJ- in forum Opportunities Available & SoughtReplies: 0Last Post: 29-01-2010, 03:06 PM
Bookmarks