Help Please With Auto Tool Height Mach 3 Problem

[howser37]

lol JAZZ, it wasnt a rats nest until i yanked it all out to get to the jack, what i don't understand is if it was a problem with the internals of the jack why would plugging in the probe trip the digitize light every time reliably?

will post some probe pictures later

thanks

[howser37]

Ok just did a test with an old set of in ear earphones, i plugged them into the jack, and the digitise light went off, in my mind this should not happen as the circuit is not complete, so i am assuming that the circuit is being completed inside the jack and therefore a probe touch cannot break this circuit as it is not just being completed in the probe but in the jack as well

[howser37]

thanks guys, got it fixed now, it was a loose terminal on the jack

[Clive S]

thanks guys, got it fixed now, it was a loose terminal on the jack

Very pleased you got it sorted. Happy milling. ..Clive