Thread: Hello everyone !
-
15-06-2014 #1
Hello all, new to the site just.
I'm a forty something newbie to CNC at least in terms of using mills etc, but I have a background in Electronics and spent a couple of very interesting years not too long ago doing component level repairs on CNC controllers, VFD's, servo's, power supplies and PLC's for a local company.
Whilst creating some brackets to mount infra red heater elements for my latest project (toaster reflow oven) - by hand - I got to thinking "There must be a better way !", so I started looking for a cheap mill.
I quickly realised that there is a large range of good and not so good equipment and that I would find a lot of value in 'lurking' with the professionals and tapping in on their experience - so here I am
Hopefully in return I may be able to give something back to the forum.
Kind Regards,
Robin Commander
-
15-06-2014 #2
Welcome Robin,
So you can repair VFD's.? Well get ready for it your just about to get mobbed by loads of folks with blown VFD's tapping up your services. . Including me.
That said feel free to tap into me and my experience.
-
15-06-2014 #3
Hi Robin, welcome to the forum. I am sure with your knowledge and experience in electronics will make you a valued member of this forum. A cnc that makes toast now that's a good idea LOL as it will make a welcome change from Drivers and VFD's becoming toast.
Mike :)
-
15-06-2014 #4
-
15-06-2014 #5
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks