. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 15-06-2014 #4
    deannos's Avatar
    Lives in LONDON, United Kingdom.
    deannos
    Last Activity: 28-12-2018 Has been a member for 9-10 years. Has a total post count of 155. Received thanks 2 times, giving thanks to others 29 times.
    Quote Originally Posted by manofgresley View Post
    Thanks Jazz, i'm just a bit confused again.
    My spec sheet for the Stepper motors say's that they are 1.8 degrees, so my maths say's that for every 360 degree rotation, requires 200 steps of the motor, the motors are wired Bipolar Parallel.where on the drive does it indicate 4x & 8x

    Ray
    http://www.leadshine.com/UploadFile/Down/M542d.pdf

    look at the bottom right of the pdf
    Last edited by deannos; 15-06-2014 at 03:44 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help withController dip switch settings and Mach3 motor tuning
    By liamo1991 in forum Motor Drivers & Controllers
    Replies: 2
    Last Post: 15-11-2013, 02:22 AM
  2. 3 wire stepper motor drivers?
    By m_c in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 17-08-2013, 10:01 PM
  3. Pulse rate or dip switch settings
    By Jopo in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 29-04-2013, 08:08 AM
  4. Setting up stepper motor drivers
    By croy in forum Motor Drivers & Controllers
    Replies: 25
    Last Post: 30-09-2012, 09:51 PM
  5. eBay Stepper Motor Drivers from China
    By Mad Professor in forum General Electronics
    Replies: 6
    Last Post: 20-07-2009, 10:54 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules