Thread: Boring Bar Suggestions?
Threaded View
-
17-06-2014 #5
Last Activity: 2 Weeks Ago
Or previously described method but leaving a tad in the bore and see if anyone can loan you a delapena hone to true it up.
I made a boring bar to go between centres with a 6mm round piece of HSS set @ 45 deg ground with cutting edge and locked with a grub screw, job was clamped to cross slide.
Mike
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Cooling pump suggestions
By martin54 in forum General ElectronicsReplies: 2Last Post: 13-02-2013, 09:07 PM -
Power Supply Suggestions please..
By Ricardoco in forum General ElectronicsReplies: 37Last Post: 30-01-2013, 06:37 PM -
Driver suggestions
By Shinobiwan in forum Motor Drivers & ControllersReplies: 0Last Post: 04-03-2012, 03:54 PM -
PLC/Programmable chip suggestions
By m_c in forum General ElectronicsReplies: 9Last Post: 02-04-2011, 04:40 PM -
Recommendations for low cost MT3 boring head...
By irving2008 in forum Tool & Tooling TechnologyReplies: 5Last Post: 19-08-2009, 10:15 AM
Bookmarks