Let the fun begin !!! ???

[PAULRO]

steel has arrived and is cut and both sidewalls are welded.


I have to string the crossbeams and tie both together.

I contacted http://www.ecfibreglasssupplies.co.uk /to purchase epoxy 105 and hardener 209 but drew a blank . apparently they don't stock 209 hardener but told me the 205 or 206 hardener are very similar but for pot time and cure time. has anybody used these hardeners? i'll probably go with the 206 because it has a longer pot life but would like some feed back before i do.

i also spoke to Chai about his linear guides and rails and the preloads are as follows
Z1: 0-0.02C or Z2: 0.02C-0.05C . i'm sure either of these will do the job but would like to know which preload is the preferred choice for wood routers.