Let the fun begin !!! ???

[JAZZCNC]

Clive Cmon he's in Ireland don't think finding a cool days is going to be a problem, . . dry day well !! . .

Paul I've used epoxy with equivalent cure times to 206 in past and had no problems but like clive says the conditions must be correct. Infact I've just ordered some 206 because ECF didn't have the 209 and couldn't wait or fancy being ripped off.( wanted nearly double the 206.!!) and I don't envisage any problems.

[PAULRO]

the frame is nearly finished. i have to weld in the table locators on each side and give it a lick of paint. it looks big ( it is ) but i said to myself that i may need upgradeability considering the growth of the DIY cncs over the past number of years and the bigger routers that are coming on stream.

i also welded the electric cabinet frame together, 800 x 600 x 200 deep ( just under 3 lengths of 20 x 20 angle). i have 1mm galvanize to sheet it and some hinges knocking about somewhere.
the frame and cabinet should be finished by next weekend and then i'll get a moat organised for the dreaded epoxy pour!!