. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 30-04-2015 #31
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by PAULRO View Post
    cheers Jazz, i watched the first video on the Mach 3 website and got mislead , again!!! the green tick( active low) did the trick o.k. i need to give the tutorials another glance again to see if i can get the motors to turn!!!
    Well if you have Mach out of E-stop and reset then your half way there. After setting correct motor port & pins then it's a simple case of motor tuning.
    Just remember to set the Native units ie Inch or mm before tuning motors otherwise you'll have to re-tune motors. Mach Default is set to Inch.!
    (restart mach if you change units)
    Last edited by JAZZCNC; 30-04-2015 at 09:26 PM.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Hello everyone. Total newbie here. Where do I begin?
    By DarkWalkJRB in forum New Member Introductions
    Replies: 2
    Last Post: 07-02-2012, 08:31 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules