Let the fun begin !!! ???

**PAULRO** · 02-05-2015

i haven't the overide wired up yet , i didn't think that would matter with regards to getting the motors to turn .

**PAULRO** · 02-05-2015

**JAZZCNC** · 02-05-2015

Looks like you hadn't set enable output. (enable1) Thats why the motors won't turn because the drive enable is being turned off.

Try this xml.

**PAULRO** · 02-05-2015

sorry Jazz , do i just unzip this and put it back into mach 3?

**JAZZCNC** · 02-05-2015

Originally Posted by PAULRO

sorry Jazz , do i just unzip this and put it back into mach 3?

Yes unzip and replace the original.

**PAULRO** · 03-05-2015

well that did the trick o.k Jazz. at least i have the motors turning which was a great milestone to reach. i have to play with it to day to get comfortable with the different noises and speeds . i thought i had a problem with having only 3 inputs available because i couldn't use input 10 or 11 .......... turned out that they only become available for use when the dedicated inputs on the bob are wired in!!! every day is a day for school!! cheers for that last night , by the way.

**JAZZCNC** · 03-05-2015

Originally Posted by PAULRO

cheers for that last night , by the way.

Erm that sounds dodgy.!!! Lets just be clear for those dirty minded types.!. . . Last night wasn't pyhisical people. . .

Glad your working now get on with making chips.. .

**PAULRO** · 04-05-2015

i had my motors tuned to 2000 steps /per in the motor tuning section and slaved the A axis . the speed and aceleration were also set at a comfortable value, lovely , i thought. i put a dial indicator on the axis and set the code with a G0 X10 but it went at least 50mm.. 60 mm so i set the steps per unit on the settings tab to bring it in to tolerance but that then throws out my ''steps per'' in my motor tuning menu.... obviously the machine travel has to be right , am i missing some setting? the motor tuning ''steps per'' is now at 160 , a far cry from 2000 .