. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 16-05-2015 #1
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    It's been awhile since I played with PLCM but will probably be the PLCM disableing the motor outputs when it see's a limit trip. Check to see if the plug-in as an option to leave motor outputs enabled.

    Not sure what "Z" Column your meaning thou.?
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

    PAULRO
  3. 16-05-2015 #2
    PAULRO's Avatar
    Lives in LIMERICK, Ireland.
    PAULRO
    Last Activity: 30-04-2020 Has been a member for 9-10 years. Has a total post count of 180. Received thanks 2 times, giving thanks to others 201 times.
    sorry, i mean the 3rd column over from the left in the'' input signal current state''. i'm not too sure about the plug in for the motion controller, the paperwork doesn't mention an option to leave the motors enabled.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Hello everyone. Total newbie here. Where do I begin?
    By DarkWalkJRB in forum New Member Introductions
    Replies: 2
    Last Post: 07-02-2012, 08:31 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules