. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 25-02-2015 #33
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    Quote Originally Posted by EddyCurrent View Post
    Well fancy that, all you time served people out there, you wasted four years of your life, it seems you didn't need to know all that stuff after all.
    Keep your knickers on Eddy wasn't saying your wrong or questioning your knowledge I'm saying 1.5mm is fine with these spindles after fitting many of these spindles without any troubles at all.!!. . Which I can't say about those being earthed at the spindle because I've had a few and seen several instances of people doing this and having ground loop troubles.

    Also 2.5mm doesn't even fit the spindle connector so I doubt they where designed to use 2.5mm.!
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Hello everyone. Total newbie here. Where do I begin?
    By DarkWalkJRB in forum New Member Introductions
    Replies: 2
    Last Post: 07-02-2012, 08:31 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules