Thread: Let the fun begin !!! ???
Threaded View
-
21-05-2015 #29
Ok think I know whats happening here. You haven't enabled and setup the Spindle output in Motor outputs so the spindle CW F5 isn't turning on or controlling output #14.
So try this first and I think you'll find it turns spindle on/off ok.
Ports & Pins -> Motor Outputs / Spindle: Enabled /Step Pin # (14)/ Step Port # (1)
On the VFD set PD001 =1 This is external source for run command
On the VFD set PD002 = 1 This is external source for Frequency.
If this works then you may need to play with Motor tuning to get the exact speed. Also go to Pulley setup and set minimum and maximum speed.Last edited by JAZZCNC; 21-05-2015 at 05:24 PM.
-
The Following User Says Thank You to JAZZCNC For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hello everyone. Total newbie here. Where do I begin?
By DarkWalkJRB in forum New Member IntroductionsReplies: 2Last Post: 07-02-2012, 08:31 PM
Bookmarks