Let the fun begin !!! ???

[Clive S]

Paulro

The relevant leds are on , on the BOB, my ports and pins are set correctly( they stop the M/C when triggered). but they only trigger briefly on the diagnostic tab. how are yours set up?

Mine are working like yours as Dean has said it will work different to the manual.
.
Regarding the homing you can adjust the racking by adjusting one of the homing switches until it is correct. X and A will back off the switches independently, it is hard to see when the gantry is square. But if you want to see it happen remove the belts (if you are using them and the are not direct drive) and put a maker tape on each motor pulley and then home the x axis if you then trip one switch the motor will reverse and stop when you release it. The same will happen to the other side. ..Clive

Some Yorkshire man beat me to it