. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 21-05-2015 #29
    PAULRO's Avatar
    Lives in LIMERICK, Ireland.
    PAULRO
    Last Activity: 30-04-2020 Has been a member for 9-10 years. Has a total post count of 180. Received thanks 2 times, giving thanks to others 201 times.
    output signals set up ,
    ouput 1 = port 1, pin 14 , active high
    output 2=port 1 , pin 16 , active high.
    ( if i toggle the active high to active low on this output, the spindle comes on .


    my motor ouputs tab is a stumbling bolck for me , should i enable the spindle ?
    i have it enabled on this tab , step pin 14, i don't know what DIR PIN to use because i have only 1 output pin ( 17) left and that's a relay .

    is this my problem . thanks in advance
    Last edited by PAULRO; 21-05-2015 at 03:07 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 5 users browsing this thread. (0 members and 5 guests)

Similar Threads

  1. NEW MEMBER: Hello everyone. Total newbie here. Where do I begin?
    By DarkWalkJRB in forum New Member Introductions
    Replies: 2
    Last Post: 07-02-2012, 08:31 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules