2 turning ops or more on solidcam?

[eamo1978]

Just tried it with a mac 2 position on the other end and says "geometry intersects with clamp" when i try and run a facing operation.....

[eamo1978]

ideally i need step by step instructions on how to do this including where the options are that im selecting. I cant find anything on the net.

[eamo1978]

Update, ive spoken to an ex work colleague and found that i run solid verify then go to file and save the job as stock to stl. Ive created the second program doing op2 of my turned part and added the stock as the stl I previously saved. Only problem now is the stl stock is the opposite way round onscreen to my component....any ideas?