Routing Tool For Quality Plastic Finish (i.e Minimal Burrs)

[Lee Roberts]

Well I gave it a try but it didn't turn out well but that may be due to the speed. Let me add that my experience with all this is minimal, I've been dropped with the task now that the operator has left.

That's a shame, sorry about that.

My next question was going to be "what speeds and feeds are you using", as pointed out by Clive, it does look like its pushing rather than cutting, I would definitely try slowing the feed down, typically the number of flutes match the number of teeth on the cutter (not always though), if you don’t have a cutter with more teeth on it try raising the rpm as well (you may not need more teeth if you get them there quicker instead), experiment with the above until you find the happy medium.

.Me