MDF and alu sandwich router

[irving2008]

Nice powersupplies and i've ordered two (can never have too many supplies hanging around!)

Note though you may need to use a reverse energy dump circuit with this supply as it has an over-volts latch off function if the output voltage exceeds 60v. With a large stepper under load the reverse EMF could cause the over-volt trip to shut the supply down (sort of like a self-inflicted e-stop)

It shouldnt be hard to tweak it to go below 50v. When I get it I'll have a look, also will advise on best way to replace the output connector with something more cost effective as the DIN41612H connectors are £10+ each without the shells. The connector on the supply is a male, so it may be possible to use female push-fit spade connectors directly on the terminal pins.