Controller card selection

[Smiler]

Hi,

I am looking to CNC a small mill and have been looking at the products from DIY CNC and Routout CNC. Does anybody have any user feedback on either product? A search brought nothing up.

Thanks

Hi Hogout.

I have had 2 DIYCNC BOB's and a DIYCNC relay board. All have been very high quality. Roy gives really good support too. I've just bought the Uniport, buffered outputs for the drivers and 3 onboard relays plus opto isolated inputs. You can't go wrong IMO.

Gary at Zapp also stocks the same boards and you can't fault him either, in fact you can contact him on this forum.

Welacome to the forum BTW

Jeff.

[korky]

I bought one of Roy's DIYCNC boards earlier this year - the System 3+
I bought it as a package with the cheapest nema23 motors.

The kit was easy to solder, and except for me not completely soldering in one of the resistor networks, worked first time. It was a doddle to set up and hasn't put a foot wrong.
I'm running all three axes at 1.5A, 1/8 step.

K.

[Hogout]

Thanks Jeff & Korky, that's really useful!!

Cheers.