Quote Originally Posted by JAZZCNC View Post
Are you for real.!

Also can I just say you are going about this all wrong regards the electronics. Roy's stuff is ok but it's more suited to smaller machines like Mills not routers. This is because the drives are low voltage with a Max of 40Vdc I believe. Routers run much higher feed rates than mills so we need more speed from the motors and steppers get there speed from volts. 40V max drives will be restrictive to a router machine unless you use a high pitch ball or lead screw and this will lower resolution so your getting a unbalanced machine.

Trying to cut costs on electronics is asking for trouble and never ends well.!!
It's not all about speed!!! From many years experience working Roy's 40Vdc drives I am on 1405 screws round supported rails, I profile 12 to 20mm aluminum with DOC of 2 to 3mm with great success also 2.5D relief's in aluminum & stone with DOC up to 4mm so I don't understand how you come to say "you would have an unbalanced machine" just not so there is no problem with Roy's drives.
For what the OP wants System 4 is a great system to use.

usual disclaimer only a very satisfied user.

Phill