Threaded View
-
10-07-2014 #1
Hi, Just a quick question. If I was to build a machine with 1500mm guide rails on X and the bearing blocks were 250mm apart (is that enough or should I spread them further) then the actual travel distance will be only 1250mm so should I order a ballscrew with an approximate length of 1300mm or would you have the ballscrew span the whole length of the MC? same goes for the Y gantry and Z too.
Cheers, Charlie
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: Any one wishing to buy a CNC length stop bench can make me a offer
By suesi34e in forum Items For SaleReplies: 3Last Post: 07-05-2014, 10:20 PM -
FOR SALE: 2x 2005 C7 Ballscrew 1450mm Length with Ballnuts + FK/FF mounts and motor coupler
By Shinobiwan in forum Items For SaleReplies: 38Last Post: 31-12-2012, 02:42 PM -
Maximum length guideline for a standard 16mm ballscrew?
By WandrinAndy in forum Lead Screws, Nuts & SupportsReplies: 5Last Post: 01-11-2012, 12:27 AM -
Ideas sought to deburr a 5mm length of 5mm dia steel!
By HankMcSpank in forum General DiscussionReplies: 9Last Post: 22-03-2010, 08:48 PM
Bookmarks