Which Type of Limit Switch

[cropwell]

Right, not used it myself. Presumably you need to set up the nominal home location and Mach3 moves far enough to the appropriate side of that to approach from the right direction.

All Mach3 does is have a set direction to move an axis when heading for home (the home sensor). After detecting the sensor Mach3 then backs off a little and zeroes the DRL. This, presumably, is not intended for having a home position in the centre of the table. I could give you some screenshots, but my Mach3 computer is disconnected whilst I rebuild the control box. If you had an input set to 0/1 depending on which half of the axis you were in, then I am sure some clever sod could write a macro to centre the axis.
I think you mentioned previously that proximity switches work on detecting ferrous metal, which is true, but mine also work on ali and brass. The ones I use are 4mm axial detection, but I use them in bypass mode, where the detection position is not necessarily 4mm, but it is consistent. In axial mode you have a great danger of jogging onto the switch and crushing the end, which kills it. (That is why I have the spares, bought as a lot of 8 from china.)

To Ray:- You have to regard a proximity switch as an off/on (ie normally open) push button switch, but it needs 6 to 36v to make it work. The ground connection is common to the switch and the electronics in there. 5v won't cause it to switch, either not at all or not reliably.
PM me with your phone number if you want to talk it through. I have got 5 LJ12A3-4-Z/BX switches and some 12v power supplies, which are intended to be used in my next build.