Well here goes... Aluminium frame router design

[CharlieRam]

Long time no post so I'd like to thank you all for your help during this build and give a little update. I decided to upgrade the x axis to use a slave drive, firstly just to get a little more speed from it but secondly because the length of the single belt worried me a little! I managed to blow the charge pump output on my AXBB twice but I have since repaired it and had no issues since. I have done a few test cuts and am quite happy with it so far although I have noticed that the x axis motors resonate quite badly on low revs. The drives are set identically to the Y and Z with the only difference being it has both X and A slaved. Any ideas? Also I'd like to wire up the fault output on the drives and am a little unsure of how to do it

Here's a linl to a youtube vid pf the machine doing a bit of the carving below

https://youtu.be/71zmWimvsMc

Thanks again...i couldn't of got this far without your help stay safe everyone.

Sent from my SM-G920F using Tapatalk

[Andrewg]

Congratulations on completing your machine - having just read through your complete build log, I was at many points not expecting it to end with this triumphant post!

I hope you would consider entering your machine details here. Hopefully someone more experienced will be along to answer your questions. As soneone plotting their own build, always keen to hear reflections and lessons from those who have made it through.
Best wishes
Andrew