Long time no post so I'd like to thank you all for your help during this build and give a little update. I decided to upgrade the x axis to use a slave drive, firstly just to get a little more speed from it but secondly because the length of the single belt worried me a little! I managed to blow the charge pump output on my AXBB twice but I have since repaired it and had no issues since. I have done a few test cuts and am quite happy with it so far although I have noticed that the x axis motors resonate quite badly on low revs. The drives are set identically to the Y and Z with the only difference being it has both X and A slaved. Any ideas? Also I'd like to wire up the fault output on the drives and am a little unsure of how to do it

Here's a linl to a youtube vid pf the machine doing a bit of the carving below

https://youtu.be/71zmWimvsMc

Thanks again...i couldn't of got this far without your help stay safe everyone.

Sent from my SM-G920F using Tapatalk