My Build

[audioandy]

Ok that seems to have worked.

So

The next photos show my machine through various stages of my build.

The first is a side view of my built up Z axis,the next is my X axis and Z parts built. The next part I built up was the table that it all was going to sit on.

After mounting to the table I started to wire in my limits and homing switches these all terminated into a junction box on the rear of my gantry I used shielded cable where possible then used a multicore shielded cable to connect them to my main control box.
The main control box was fastened to the side of the table then the Y axis was built up and assembled.