Redesign...Steel is now Extrusion

[JAZZCNC]

This machine was designed just for cutting wood and soft materials, it does cut aluminium but it was never intended or design for that purpose. If you asked me to build a machine for cutting ali you wouldn't get this machine.!

One other thing which I did point out to you in an email is the gantry cross brace being "L" shaped, this is the Key to it's strength in resiting flex etc and giving best support with high sides. One thin single piece isn't enough to resist flex when cutting hard with highsides. Esp with single screw down centre.

Here's a differant machine to what Lee posted but built exactly same fully covered and finished.! . . . . . This is a single ballscrew machine but there's a larger twin screw version. (Also a smaller Baby version)