'T - something and counting....'

[EddyCurrent]

If any kind soul could help me identify which parameters I should set to get the thing spinning, that would be much appreciated. I've got the standard Chinese 2.2kw water cooled spindle and am just looking to input the bare minimum of settings to get it going (i.e.the equivalent of the Huanyang settings in the set-up and advice thread).

Try these for a start, Huanyang on the left, yours on the right. Normally with a vfd you set the motor parameters first but in the case of your inverter the available settings seem oddly inadequate.
I don't know how you have the I/O wired so it may not run until you get those correct i.e. forward, run, stop, etc. Try using the keypad first.

PD013 .... 13-08
PD005 .... 00-12
PD007 .... 01-08
PD008 .... 01-01
PD011 .... 00-13
PD014 .... 00-14
PD015 .... 00-15
PD142 .... 02-01
PD144 .... 02-01